Nixie Clock Build GN-4, Proximity Sensor, GPS & Dekatron

More
10 months 4 weeks ago #11911 by mclegg
Hello again,
So for the slowest clock build ever (I only get to it abut once every two months).

Looking at the RCWL-0516 microwave sensor. I cant find too much about how this should be wired. Im assuming the same pins as the PIR to the board, however this has more outputs than the PIR. So just want to confirm really. Ideas here? Im running from the Classic Rev_6 board.

Cheers for your help once again.

Please Log in or Create an account to join the conversation.

More
10 months 4 weeks ago #11913 by Ty_Eeberfest
Please refer to this post:
www.tubeclockdb.com/forum/12-arduino-nix...ssion?start=24#11706

Any pins not mentioned are not used. You only want to hook up power, ground and 1 signal.

Look into it later when the dust is clearing off the crater.

Please Log in or Create an account to join the conversation.

Moderators: AccutronTy_EeberfestIan
Time to create page: 0.094 seconds
Go to top
JSN Boot template designed by JoomlaShine.com