Nixie healing mode on MNC6

More
5 months 4 days ago #12895 by Thesh111t
Thanks. Now I just need to figure out why I can't log into the clock anymore. Lol
Attachments:

Please Log in or Create an account to join the conversation.

More
5 months 3 days ago #12899 by Thesh111t
So I moved the problem tube to the 10 seconds spot and while I couldn't turn the motion sensor off i did set it 3600 seconds (I believe that was the max setting) and ill see how things go. I think my WiFi board failed (it only had a red light, no blue blinking light and i couldnt connect to it). I switched it out for another board I have and the clock is back up and running (And communicating). I'll see if the tube heals over a few days time. If not I guess ill just put it in the hours spot where the 2 is not used at all. Thanks again for the help.

Please Log in or Create an account to join the conversation.

More
5 months 2 days ago #12902 by Ty_Eeberfest
Just out of curiosity, did you get the now-failed ESP as part if a kit from Ian or did you buy just a PCB and are sourcing all the parts yourself? It just seems like we've been hearing a lot about apparently bad ESPs lately and I'm wondering where they are coming from.

Look into it later when the dust is clearing off the crater.

Please Log in or Create an account to join the conversation.

More
5 months 2 days ago #12903 by Ian
Replied by Ian on topic Nixie healing mode on MNC6
I think it's my problem: they work and then they just stop. I don' have a good feel of the failure rate yet, but there is certainly something going on. It's killing me slowly: $4 shipping each time for a $1 part, I might well just start putting a spare in the kit right from the start. :-/

Please Log in or Create an account to join the conversation.

More
5 months 2 days ago - 5 months 2 days ago #12904 by Thesh111t
I got the wifi board out another one of Ian's kits. I haven't sourced any parts from anyone else other than the IN14 tubes. I purchased 3 of his kits so i borrowed the WiFi board from another kit. In all fairness, it did work properly when It arrived. It however stopped working a week or so after putting the clock in use
Last edit: 5 months 2 days ago by Thesh111t.

Please Log in or Create an account to join the conversation.

More
5 months 2 hours ago #12909 by Thesh111t
Well 2 days with the faulty tube in the 10 seconds place and the 2 is still acting up. I've given up on it and have moved it to the 0/1 hour place at the end of the clock.

Please Log in or Create an account to join the conversation.

Moderators: AccutronTy_EeberfestIan
Time to create page: 0.105 seconds
Go to top
JSN Boot template designed by JoomlaShine.com