-
Forum
-
Main Forum
-
Arduino Nixie Clock Kit Support Forum
-
4-Digit Wemos Clock or SNC4/6 4-Digit Nixie Clock
4-Digit Wemos Clock or SNC4/6 4-Digit Nixie Clock
Less
More
-
Posts: 1208
-
Thank you received: 128
-
-
-
-
1 year 3 months ago #12485
by Ian
It is a sandwich construction and has indivdually addressable NeoPixels. I really need to get some pictures of it up - I'll have a look at putting some more info into the manual.
Please Log in or Create an account to join the conversation.
Less
More
-
Posts: 34
-
Thank you received: 0
-
-
-
-
-
1 year 3 months ago #12486
by ebretteville
The thing is that this ser manuel says it supports:
Operating Instructions
Firmware V1
Supported Models:
MNC6
Note the one I'm talking about
Please Log in or Create an account to join the conversation.
Less
More
-
Posts: 34
-
Thank you received: 0
-
-
-
-
-
1 year 3 months ago #12487
by ebretteville
OK so it's basicaly the same as the one in a KIT samller with a black PCB and assembled?
I read through the forum and came by the "problem" that the neopixel is "far" from the tubes especially if you use (like me) support for tubes for the KIT. Is this assembled as the same design?
Please Log in or Create an account to join the conversation.
Less
More
-
Posts: 34
-
Thank you received: 0
-
-
-
-
-
1 year 3 months ago #12516
by ebretteville
What about proposing some tube holders (for MNC6 6-Digit Nixie Clock for example) with neo pixels leds on it for people using tubes sockets and same for display board for the wemos/Assembled 4-Digit Small Tube Nixie Clock in order to avoid the light guidance tubes or classique led replacement?
Please Log in or Create an account to join the conversation.
Less
More
-
Posts: 34
-
Thank you received: 0
-
-
-
-
-
1 year 3 months ago - 1 year 3 months ago #12517
by ebretteville
OK so it's basicaly the same as the one in a KIT samller with a black PCB and assembled?
I read through the forum and came by the "problem" that the neopixel is "far" from the tubes especially if you use (like me) support for tubes for the KIT. Is this assembled as the same design?
Any update on that question?
Please Log in or Create an account to join the conversation.
Less
More
-
Posts: 1208
-
Thank you received: 128
-
-
-
-
1 year 3 months ago #12518
by Ian
Yes, the NeoPixel is about 10mm away from the hole in the display board. However the display board uses receptacles so that the tube is not high and far away from the display.
I think it is a good solution.
The two boards
Assembled
How it looks when in a case
Please Log in or Create an account to join the conversation.
-
Forum
-
Main Forum
-
Arduino Nixie Clock Kit Support Forum
-
4-Digit Wemos Clock or SNC4/6 4-Digit Nixie Clock
Time to create page: 0.099 seconds