"Modular" 6-digit Arduino Nixie Clock - wifi access

More
5 months 3 weeks ago #11930 by reglings
Hi all,

I built the "Modular" 6-digit Arduino Nixie Clock with wifi kit and was able to connect to the hotspot, then followed the procedure.

After that, I am able to connect to the clock in my local network and have access to the summary page .

It shows as "Nixie clock", and has sections "Current Status" and "ESP8266 information.

Now the question is - how do I enter "Configure clock settings" section, since I am prompted for a username/password?.

Please Log in or Create an account to join the conversation.

More
5 months 3 weeks ago #11932 by BS_Jim
Hi reglings,

For the Configure Clock Settings page, the default username is "admin" and the password is either "setup" or "update" (without the quotes). I'm pretty sure it's "setup" and "update is only for doing OTA updates.

Please Log in or Create an account to join the conversation.

More
5 months 3 weeks ago #11933 by reglings
Thank you, "setup" worked.

Please Log in or Create an account to join the conversation.

More
5 months 3 weeks ago #11935 by BS_Jim
Mark it on a piece of tape and stick it to the underside of your clock. I went to look it up for you but remembered it's no in any obvious place in the manual, so I just tried to log into my clock. Maybe Ian could remedy that in the next manual revision.

Please Log in or Create an account to join the conversation.

Moderators: AccutronTy_EeberfestIan
Time to create page: 0.105 seconds
Go to top
JSN Boot template designed by JoomlaShine.com