Re: Putting in-16 tubes in an in-14 clock kit

More
4 years 10 months ago #7251 by dg2assassin
I got confirmation that the in-14 clock kit I am looking at is able to power in-16 tubes. The only problem is that the wiring is different. I found two pin out charts that helps for the numbers but the other three pin outs I'm not completely sure on.
So my question is, were are the other three wire suppose to go from in-14 to in-16. I can also provide the two charts that I have found if you guys would want to see them.

Please Log in or Create an account to join the conversation.

More
4 years 10 months ago #7252 by nixiekid
I've been a lurker for a time, but I also am interest in this question. I love tiny IN-16 tubes and it exist not many kits for them.

What is the kit that you want to use? Is there schematic?

Please Log in or Create an account to join the conversation.

More
4 years 10 months ago #7255 by Ty_Eeberfest
Post the info you have and i can probably figure it out. A schematic of the kit would be helpful too.

Look into it later when the dust is clearing off the crater.

Please Log in or Create an account to join the conversation.

More
2 months 2 weeks ago #12659 by Ian
Just to mention, my new clock has tube holders for IN-16:

www.nixieclock.biz/StoreMNC6.html

Please Log in or Create an account to join the conversation.

Moderators: AccutronTy_EeberfestIan
Time to create page: 0.095 seconds
Go to top
JSN Boot template designed by JoomlaShine.com