I2C issues

More
1 year 1 month ago #8056 by lays
I build a clock based on the all in one, but with the logic level shifter for the wifi on board.
The circuit and connector are only a few cm from the ATMEGA away, but i gety lots of I2C connections and changes with every refresh.
There is also an RTC connector nearby, if i use that with a logiclevel shifter board which works with another clock i get the same behaviour.

Anybody got a clue on this?

Attachments:

Please Log in or Create an account to join the conversation.

More
1 year 1 month ago #8057 by Ian
no, never seen that before. I can't really help you unless you give some more info like the board layout and software version you are using.

Please Log in or Create an account to join the conversation.

More
1 year 1 month ago #8058 by lays
hI Ian,

clock version is 49, wifi 1.06
schematic is all in one rev2 with wifi logic level shifter on board

Please Log in or Create an account to join the conversation.

More
1 year 1 month ago #8060 by BS_Jim
Hmm. That's pretty strange. Have you tried another Atmega and checked the I2C connections?

Please Log in or Create an account to join the conversation.

More
1 year 1 month ago #8061 by lays
I tried a different atmega and esp-01 without avail. Checken connections to the atmega.

I have another atmega and esp-01. Will program these and check again

Please Log in or Create an account to join the conversation.

More
1 year 1 month ago #8062 by lays
It seems i made an error in the design. 1 trace which goes to the fet and the 3k resistor touches the sda line. thank you eagle for mentioning that during error check :(

Please Log in or Create an account to join the conversation.

Moderators: AccutronTy_EeberfestIan
Time to create page: 0.091 seconds

Search

Tube Suppliers

Go to top
JSN Boot template designed by JoomlaShine.com